Product Description
Spinalator Roller - Replacement Spinalator Rollers
These Replacement Rollers are for Spinalator Table with Electric Roller Height Elevation
New Rollers are Black, Higher Density Foam!
The Spinalator Roller Kit Includes
High Density Rollers - Qty 3
New Style steel one piece bearing- Qty 3
Bolts with Lock Washers Qty 6
Spinalator Rollers comes with Set of three High Density Rollers, Steel bearings, bolts, & lock washers. These replacement Spinalator rollers will fit all Spinalators with electric elevation.
The picture below shows an oldest style Spinalator with Manual Roller elevation. It uses a very OLD 3 arm, mounting system. You MUST purchase the old style UPDATE KIT!!!
- Remove top from Spinalator by unclasping end brackets.
- Make sure hands are clear of any moving parts and turn table timer on. Elevate Roller to top height
- Turn Roller rotation switch OFF, with one roller centered to the top of the triangle assembly.
- UNPLUG TABLE - Some Spinalator's have a auto retract to lower rollers. Failure to UNPLUG table will let the roller retract automatically. This could cause bodily injury or tear up your new Spinalator rollers! This will also keep you from getting shocked if you happen to touch a exposed wire.
- 1st Roller-Remove Bolt from Roller and remove old Spinalator Roller. Install new Spinalator roller, New style roller will have a easy one piece bearing and dual bolt for ends. Make sure and use provided Lock Washer!!!
- Ensure Hands, tools, and anything else is clear of rollers then plug up table. Turn Spinalator rotation switch on and cycle roller to next top height and shut off rotation switch again.
- UNPLUG TABLE - Some Spinalator's have a auto retract to lower rollers. Failure to UNPLUG table will let the roller retract automatically. This could cause bodily injury or tear up your new Spinalator rollers! This will also keep you from getting shocked if you happen to touch a exposed wire.
- 2nd Roller-Remove Bolt from Roller and remove old Spinalator Roller.