Product Description
Spinalator IST Table Roller Kit
- for Manual Crank Roller Elevation Table ONLY
- Wagon Wheel Spinalator Table Rollers
Product on BackOrder until further notice!
These Replacement Rollers are for Spinalator Table with Manual Roller Height Elevation
New Rollers are Black, Higher Density Foam!
The Spinalator Roller Kit Includes
High Density Rollers - Qty 3
New Style steel one piece bearing- Qty 3
Adapter Threaded rods Qty 6
Old Style Spinalator IST Table Rollers comes with Set of three High Density Rollers, Steel bearings, & Adapter Threaded Rods. These replacement Spinalator rollers will fit all Spinalator IST Tables with Manual or Wagon Wheel Type elevation roller mounting system ( shown in pictures ). You MUST buy this style Roller update kit for the OLDER Manual Roller Elevation Spinalator IST Table or Spinalator Wagon Wheel Table.
- Remove top from Spinalator by unclasping end brackets.
- Make sure hands are clear of any moving parts and turn table timer on. Elevate Roller to top height
- Turn Roller rotation switch OFF, with one roller centered to the top of the triangle assembly.
- UNPLUG TABLE - Failure to do this could cause bodily injury or tear up your new Spinalator rollers! This will also keep you from getting shocked if you happen to touch a exposed wire.
- Loosen Set screw from Roller and remove old Spinalator Roller. Install new Spinalator roller, New style roller will have a easy one piece bearing. Screw In Threaded adapter rod into bearing until it is flush on both sides then tighten down Set Screw.
- Ensure Hands, tools, and anything else is clear of rollers then plug up table. Turn Spinalator rotation switch on and cycle roller to next top height and shut off rotation switch again.
- UNPLUG TABLE - Failure to do this could cause bodily injury or tear up your new Spinalator rollers! This will also keep you from getting shocked if you happen to touch a exposed wire.
- Loosen Set screw from Roller and remove old Spinalator Roller. Install new Spinalator roller, New style roller will have a easy one piece bearing. Screw In Threaded adapter rod into bearing until it is flush on both sides then tighten down Set Screw.
- Ensure Hands, tools, and anything else is clear of rollers then plug up table. Turn Spinalator rotation switch on and cycle roller to next top height and shut off rotation switch again.
- Final Roller -UNPLUG TABLE - Loosen Set screw from Roller and remove old Spinalator Roller. Install new Spinalator roller, New style roller will have a easy one piece bearing. Screw In Threaded adapter rod into bearing until it is flush on both